Windster RA-14L30SS Bedienungsanleitung

www.windsterhood.com User’s Manual RA-14L30SS RA-14L36SS Please read this operation manual thoroughly before using your range hood. Store it in a sa

9 INSTALLATION DIAGRAM INSTALLATION DIAGRAM

10 OPERATION & FEATURES OPERATION & FEATURES 1. EASY ACCESS CONTROL SWITCH (from left to right) a. Button 1 – ON / DELAY SHUTOFF / OFF b. B

CLEANING & MAINTENANCE 11 CLEANING & MAINTENANCE ..WARNING!!!.. To prevent the possibility of a fire and explosion, do not use flammable liq

TROUBLESHOOTING 12 TROUBLESHOOTING ..WARNING!!!.. Check to make sure all power sources are disconnected before starting any troubleshooting. Safety

PART LIST / REPLACEMENT 13 PART LIST / REPLACEMENT # Description # Description 1 Duct cover bracket 9 Control support panel 2 Duct cover 10 Control

WARRANTY / CONTACT US 14 WARRANTY / CONTACT US LIMITED WARRANTY Windster Hoods Inc. warrants its product against defects in material or workmanshi

WARRANTY / CONTACT US 15 WHAT IS NOT COVERED BY MANUFACTURE WARRANTY 1. Damages resulting from any of the following:a. Improper installation or mainte

1 TABLE OF CONTENTS Table of Contents Safety Information ... 2 – 3 Content Checklist ...

2 SAFETY INFORMATION SAFETY INFORMATION TO REDUCE THE RISK OF A FIRE, ELECTRICAL SHOCK, AND/OR INJURY OBSERVE THE FOLLOWING:  Unit is intended for

3 SAFETY INFORMATION TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:  Regardless of heat level, never leave any surface materials unattended while o

4 CONTENT CHECKLIST CONTENT CHECKLIST 1. CONTENTS INCLUDED a. (1) RA14L series (30” or 36”) hood assembly b. (1) Lower duct cover (14-1/4”) c. (1)

5 MEASUREMENTS

6 PREPARATION PREPARATION 1. BEFORE YOU START **BE SURE YOUR UNIT WILL FIT YOUR CEILING HEIGHT** a. Be sure you have all the content of your purchas

INSTALLATION 7 INSTALLATION 1. WALL MOUNT INSTALLATION a. Make sure all preparation steps are completed. b. Determine your ceiling height to see i

INSTALLATION 8 3. COLD WEATHER INSTALLATION (OPTIONAL) a. Check with your local building codes to see if a CFM reducer is an acceptable alternative