Windster WS38U30SS Bedienungsanleitung PDF herunterladen (Seite 13)

i. Secure the adaptor with the screws provided.

j. Conversion is complete after the adaptor is secured (Fig. 4j)

Fig. 4j

k. Feed the wires coming out of the hood through the bottom of the cabinet.

l. Lift the unit up flesh against the wall and the bottom of the cabinet.

m. Using the screws and washers provided, insert into each of the 4 keyhole

openings (2 on each side) and tightly secure the unit against the bottom

of the cabinet.

NOTE: Install more screws through the back of the unit if necessary.

n. Connect 3-1/4” x 10” rectangular ducting to the collar of the hood.

o. Finish off by sealing the connection point with aluminum tape.

5. COLD WEATHER INSTALLATION (OPTIONAL)

NOTE: WS38CFMR is only compatible with 6” top round outlet

a. Check with your local building codes to see if a CFM reducer is an

acceptable alternative to make-up air.

b. Remove the WS38CFMR (CFM Reducer) and inspect for any sign of

defect or damage. (ie. Cracks, broken flips)

c. AFTER COMPLETING Step A – D of Section 1 UNDER CABINET

INSTALLATION (Top round outlet)

d. Place the CFM reducer onto the outlet of the unit and seal the connection

point with aluminum tape. (Be sure it is secured with no opening or gaps)

e. Connect a 6” ducting to the collar of the CFM reducer.

f. Finish off by sealing other connection points with aluminum tape.

NOTE: If using CFM reducer, you must connect the reducer to unit

before continuing.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Keine Kommentare

Windster WS38U30SS Bedienungsanleitung Seite 13